Experimental Induction of Bacterial Resistance to the Antimicrobial Peptide Tachyplesin I and Investigation of the Resistance Mechanisms.

Tachyplesin I is a 17-amino-acid cationic antimicrobial peptide (AMP) with a typical cyclic antiparallel ß-sheet structure that is a promising therapeutic for infections, tumors, and viruses. To date, no bacterial resistance to tachyplesin I has been reported. To explore the safety of tachyplesin I as an antibacterial drug for wide clinical application, we experimentally induced bacterial resistance to tachyplesin I by using two selection procedures and studied the preliminary resistance mechanisms. Aeromonas hydrophila XS91-4-1, Pseudomonas aeruginosa CGMCC1.2620, and Escherichia coli ATCC 25922 and F41 showed resistance to tachyplesin I under long-term selection pressure with continuously increasing concentrations of tachyplesin I. In addition, P. aeruginosa and E. coli exhibited resistance to tachyplesin I under UV mutagenesis selection conditions. Cell growth and colony morphology were slightly different between control strains and strains with induced resistance. Cross-resistance to tachyplesin I and antimicrobial agents (cefoperazone and amikacin) or other AMPs (pexiganan, tachyplesin III, and polyphemusin I) was observed in some resistant mutants. Previous studies showed that extracellular protease-mediated degradation of AMPs induced bacterial resistance to AMPs. Our results indicated that the resistance mechanism of P. aeruginosa was not entirely dependent on extracellular proteolytic degradation of tachyplesin I; however, tachyplesin I could induce increased proteolytic activity in P. aeruginosa Most importantly, our findings raise serious concerns about the long-term risks associated with the development and clinical use of tachyplesin I.

Effectiveness of ultrasound, UV-C, and photocatalysis on inactivation kinetics of Aeromonas hydrophila.

In this study, bactericidal effects of 24 kHz ultrasound, ultraviolet (UV-C) irradiation, and titanium dioxide (TiO2) photocatalyst were studied on inactivation of Aeromonas hydrophila, an emerging pathogen listed on the US Environmental Protection Agency's (US EPA) candidate contaminant list. Metabolic activity (using the AlamarBlue dye) assays were performed to assess the residual activity of the microbial cells after the disinfection treatments along with culture-based methods. A faster inactivation rate of 1.52 log min(-1) and inactivation of 7.62 log10 was observed within 5 min of ultrasound exposure. Ultrasound treated cells repaired by 1.4 log10 in contrast to 5.3 log10 repair for UV-C treated cells. Ultrasound treatment significantly lowered the reactivation of Aeromonas hydrophila in comparison to UV-C- and UV-C-induced photocatalysis. Ultrasound appeared to be an effective means of inactivating Aeromonas hydrophila and could be used as a potential disinfection method for water and wastewater reuse.

Influence of external bacterial structures on the efficiency of photodynamic inactivation by a cationic porphyrin.

The main targets of photodynamic inactivation (PDI) are the external bacterial structures, cytoplasmic membrane and cell wall. In this work it was evaluated how the external bacterial structures influence the PDI efficiency. To reach this objective 8 bacteria with distinct external structures were selected; 4 Gram-negative bacteria (Escherichia coli, with typical Gram-negative external structures; Aeromonas salmonicida, Aeromonas hydrophila both with an S-layer and Rhodopirellula sp., with a peptidoglycan-less proteinaceous cell wall and with cytoplasm compartmentalization) and 4 Gram-positive bacteria (Staphylococcus aureus, with typical Gram-positive external structures; Truepera radiovictrix, Deinococcus geothermalis and Deinococcus radiodurans, all with thick cell walls that give them Gram-positive stains, but including a second complex multi-layered membrane and structurally analogous to that of Gram-negative bacteria). The studies were performed in the presence of 5,10,15,20-tetrakis(1-methylpyridinium-4-yl)porphyrin tetraiodide (Tetra-Py(+)-Me) at 5.0 µM with white light (40 W m(-2)). The susceptibility of each bacteria to PDI by Tetra-Py(+)-Me was dependent on bacteria external structures. Although all Gram-positive bacteria were inactivated to the detection limit (reduction of ∼8 log) after 60-180 min of irradiation, the inactivation followed distinct patterns. Among the Gram-negative bacteria, E. coli was the only species to be inactivated to the detection limit (∼8 log after 180 min). The efficiency of inactivation of the two species of Aeromonas was similar (reduction of ∼5-6 log after 270 min). Rhodopirellula was less susceptible (reduction of ∼4 log after 270 min). As previously observed, the Gram-positive bacteria are more easily inactivated than Gram-negative strains, and this is even true for T. radiovictrix, D. geothermalis and D. radiodurans, which have a complex multi-layered cell wall. The results support the theory that the outer cell structures are major bacterial targets for PDI. Moreover, the chemical composition of the external structures has a stronger effect on PDI efficiency than complexity and the number of layers of the external coating, and lipids seem to be an important target of PDI.

Effects of material morphology on the phototoxicity of nano-TiO2 to bacteria.

Nanostructured titania (nano-TiO2) is produced in diverse shapes, but it remains largely unknown how tuning the morphology of nano-TiO2 may alter its toxicity. Herein, we show that material morphology plays a critical role in regulating the phototoxicity of nano-TiO2 to bacteria. Low-dimensional nano-TiO2, including nanotubes, nanorods, and nanosheets, were synthesized hydrothermally, and their effects on the bacterial viability of Escherichia coli and Aeromonas hydrophila were compared to spherical nanostructures (anatase nanospheres and P25). Results reveal that TiO2 nanotubes and nanosheets are less phototoxic than their rod- and sphere-shape counterparts under simulated solar irradiation. None of the tested nano-TiO2 shows toxicity in the dark. In contrast to their diminished phototoxicity, however, TiO2 nanotubes and nanosheets exhibit comparable or even higher photoactivity than other nanostructures. Observations by scanning transmission electron microscopy suggest that material morphology influences nano-TiO2 phototoxicity by governing how nano-TiO2 particles align at the bacterial cell surface. Overall, when comparing materials with different morphologies and dimensionality, nano-TiO2 phototoxicity is not a simple function of photocatalytic reactivity or ROS production. Instead, we propose that the evaluation of nano-TiO2 phototoxicity encompasses a three-pronged approach, involving the intrinsic photoactivity, aggregation of nano-TiO2, and the nano-TiO2/bacteria surface interactions.

Thin-film fixed-bed reactor for solar photocatalytic inactivation of Aeromonas hydrophila: influence of water quality.

BACKGROUND: Controlling fish disease is one of the major concerns in contemporary aquaculture. The use of antibiotics or chemical disinfection cannot provide a healthy aquaculture system without residual effects. Water quality is also important in determining the success or failure of fish production. Several solar photocatalytic reactors have been used to treat drinking water or waste water without leaving chemical residues. This study has investigated the impact of several key aspects of water quality on the inactivation of the pathogenic bacterium Aeromonas hydrophila using a pilot-scale thin-film fixed-bed reactor (TFFBR) system. RESULTS: The level of inactivation of Aeromonas hydrophila ATCC 35654 was determined using a TFFBR with a photocatalytic area of 0.47 m(2) under the influence of various water quality variables (pH, conductivity, turbidity and colour) under high solar irradiance conditions (980-1100 W m(-2)), at a flow rate of 4.8 L h(-1) through the reactor. Bacterial enumeration were obtained through conventional plate count using trypticase soy agar media, cultured in conventional aerobic conditions to detect healthy cells and under ROS-neutralised conditions to detect both healthy and sub-lethally injured (oxygen-sensitive) cells. The results showed that turbidity has a major influence on solar photocatalytic inactivation of A. hydrophila. Humic acids appear to decrease TiO(2) effectiveness under full sunlight and reduce microbial inactivation. pH in the range 7-9 and salinity both have no major effect on the extent of photoinactivation or sub-lethal injury. CONCLUSIONS: This study demonstrates the effectiveness of the TFFBR in the inactivation of Aeromonas hydrophila under the influence of several water quality variables at high solar irradiance, providing an opportunity for the application of solar photocatalysis in aquaculture systems, as long as turbidity remains low.

Thin-film fixed-bed reactor (TFFBR) for solar photocatalytic inactivation of aquaculture pathogen Aeromonas hydrophila.

BACKGROUND: Outbreaks of infectious diseases by microbial pathogens can cause substantial losses of stock in aquaculture systems. There are several ways to eliminate these pathogens including the use of antibiotics, biocides and conventional disinfectants, but these leave undesirable chemical residues. Conversely, using sunlight for disinfection has the advantage of leaving no chemical residue and is particularly suited to countries with sunny climates. Titanium dioxide (TiO2) is a photocatalyst that increases the effectiveness of solar disinfection. In recent years, several different types of solar photocatalytic reactors coated with TiO2 have been developed for waste water and drinking water treatment. In this study a thin-film fixed-bed reactor (TFFBR), designed as a sloping flat plate reactor coated with P25 DEGUSSA TiO2, was used. RESULTS: The level of inactivation of the aquaculture pathogen Aeromonas hydrophila ATCC 35654 was determined after travelling across the TFFBR under various natural sunlight conditions (300-1200 W m(-2)), at 3 different flow rates (4.8, 8.4 and 16.8 L h(-1)). Bacterial numbers were determined by conventional plate counting using selective agar media, cultured (i) under conventional aerobic conditions to detect healthy cells and (ii) under conditions designed to neutralise reactive oxygen species (agar medium supplemented with the peroxide scavenger sodium pyruvate at 0.05% w/v, incubated under anaerobic conditions), to detect both healthy and sub-lethally injured (oxygen-sensitive) cells. The results clearly demonstrate that high sunlight intensities (≥ 600 W m(-2)) and low flow rates (4.8 L h(-1)) provided optimum conditions for inactivation of A. hydrophila ATCC 3564, with greater overall inactivation and fewer sub-lethally injured cells than at low sunlight intensities or high flow rates. Low sunlight intensities resulted in reduced overall inactivation and greater sub-lethal injury at all flow rates. CONCLUSIONS: This is the first demonstration of the effectiveness of the TFFBR in the inactivation of Aeromonas hydrophila at high sunlight intensities, providing proof-of-concept for the application of solar photocatalysis in aquaculture systems.

Photodynamic inactivation of Aeromonas hydrophila by cationic phthalocyanines with different hydrophobicity.

Antibacterial photodynamic therapy is a pioneering method for the inactivation of pathogenic bacteria. Four tetra alkyl-substituted cationic phthalocyanines with different hydrocarbon chains attached to the pyridyloxy group were synthesized. These photodynamic sensitizers were studied for antibacterial inactivation of a multidrug-resistant strain of Gram-negative bacterium Aeromonas hydrophila. Aeromonas species are recognized as etiological agents of a wide spectrum of diseases in humans and animals. The uptake of phthalocyanines by the bacterial cells decreased with an increase in cell density. Following the phthalocyanine solubility from hydrophilic to hydrophobic complexes, the accumulation capacity increased. Full inactivation was achieved with phthalocyanine with (methoxy) pyridyloxy substitution following a short exposure time, low drug concentration and mild irradiation. Although the phthalocyanine with the longest hydrocarbon chain (C12) has some toxic effect in the absence of light, substantial phototoxic effect was obtained with the optimal combination of drug-irradiation parameters.

Impact of non-Legionella bacteria on the uptake and intracellular replication of Legionella pneumophila in Acanthamoeba castellanii and Naegleria lovaniensis.

In aquatic environments, Legionella pneumophila survives, in association with other bacteria, within biofilms by multiplying in free-living amoebae. The precise mechanisms underlying several aspects of the uptake and intracellular replication of L. pneumophila in amoebae, especially in the presence of other bacteria, remain unknown. In the present study, we examined the competitive effect of selected non-Legionella bacteria (Escherichia coli, Aeromonas hydrophila, Flavobacterium breve, and Pseudomonas aeruginosa) on the uptake of L. pneumophila serogroup 1 by the amoebae Acanthamoeba castellanii and Naegleria lovaniensis. We also investigated their possible influence on the intracellular replication of L. pneumophila in both amoeba species. Our results showed that the non-Legionella bacteria did not compete with L. pneumophila for uptake, suggesting that the amoeba hosts took in L. pneumophila through a specific and presumably highly efficient uptake mechanism. Living and heat-inactivated P. aeruginosa best supported the replication of L. pneumophila in N. lovaniensis and A. castellanii, respectively, whereas for both amoeba species, E. coli yielded the lowest number of replicated L. pneumophila. Furthermore, microscopic examination showed that 100% of the A. castellanii and only 2% of the N. lovaniensis population were infected with L. pneumophila at the end of the experiment. This study clearly shows the influence of some non-Legionella bacteria on the intracellular replication of L. pneumophila in A. castellanii and N. lovaniensis. It also demonstrates the different abilities of the two tested amoeba species to serve as a proper host for the replication and distribution of the human pathogen in man-made aquatic environments such as cooling towers, shower heads, and air conditioning systems with potential serious consequences for human health.

Combined effect of gamma-irradiation and conventional cooking on Aeromonas hydrophila in meatball.

Irradiation combined with a conventional cooking procedure was applied to meatball and the effects on bacterial load and inoculated Aeromonas hydrophila were determined. Meatball samples were irradiated by using a 60Co source at the dose levels of 0, 0.30, 0.75, 1.50, 2.50 kGy and cold stored at 4 +/- 1 degrees C for 7 days. Bacterial load and the count of A. hydrophila decreased when the irradiation dose level increased. A minimum inhibition effect was found at the dose of 0.30 kGy. Irradiation in combination with a conventional cooking procedure was found to be more effective in reducing A. hydrophila and the bacterial load in meatball. This study indicated that a dose of 0.75 kGy was sufficient to destroy approximately 10(4) cfu/g of A. hydrophila in meatball.